Initial Assembly; Seat Installation; Seat And Controller Assembly View - Pride Mobility Jazzy Select Owner's Manual

INITIAL ASSEMBLY

Your power chair may require some assembly either before initial use or after transportation.
NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be
replaced with a new nylon insert lock nut. Nylon insert lock nuts should not be reused as it may cause damage
to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local
hardware stores or through your authorized Pride Provider.

Seat Installation

It may be necessary to install the seat either prior to initial operation or after transporting your power chair.
WARNING! Do not pick up the seat frame
by the armrests. They are free to pivot, and
you may lose control of the seat if they do
so, resulting in personal injury or damage
to the chair.
To install the seat:
1. Slide the seat down onto the power base. See figure 10.
NOTE: The bottom hole on the seat post is equipped with
an internal welded pin, which sets the seat height in the
lowest position. If a seat height other than the lowest
position is desired, you must install the supplied clevis
pin into either the middle hole or top hole on the seat
post before installing the seat.
2. Tighten and clamp the quick-release fastener. See figure 11.
3. Install the joystick module into one of the armrests. Tighten
the setscrew with the supplied hex key. See figure 10.
4. Route the joystick module cable as shown and secure with
wire-ties. See figure 10.
WARNING! Prevent controller har ness
damage! Use correct tie-down points for
controller harness.
5. Plug the joystick module cable into the connector on the
power base. See figure 6.
Jazzy Select
I V . A S S E M B L Y
www.pridemobility.com
WIRE TIES
POWER BASE
Figure 10. Seat and Controller Assembly
SETSCREW
SEAT
JOYSTICK
MODULE
CLEVIS PIN
QUICK RELEASE
FASTENER
21