Daily Checks; Weekly Checks; To Check The Brakes; Storage - Pride Mobility Jazzy Select Owner's Manual

Jazzy select power chair
Hide thumbs Also See for Jazzy Select:
Table of Contents

Advertisement

V I I I .
! The body shroud has been sprayed with a clear sealant coating. You can apply a light coat of car wax to help it retain
its high-gloss appearance.
! All wheel bearings are prelubricated and sealed. They require no subsequent lubrication.

Daily Checks

! With the controller system turned off, check the joystick. Make sure it is not bent or damaged and that it returns to the
neutral position when you release it. Check the rubber boot around the base of the joystick for damage. Visually
inspect the boot. Do not handle or try to repair it. See your authorized Pride Provider if there is a problem.
! Visually inspect the joystick module cable. Make sure that it is not frayed, cut, or has any wires exposed. See your
authorized Pride Provider if there is a problem.
! Check for flat spots on solid tires. Flat spots could adversely affect stability.

Weekly Checks

! Disconnect and inspect the joystick module from the power base. Look for corrosion. Contact your authorized Pride
Provider if necessary.
! Ensure that all parts of the controller system are securely fastened to your power chair. Do not overtighten any screws.
! Check for proper tire inflation. There should be 35 psi (2.4 bar) in each tire. If a tire does not hold air, see an
authorized Pride Provider for replacement of the tube.
! Calibrate the joystick if a noticeable difference in performance is detected or if the joystick does not operate properly.
To calibrate the joystick, power off the unit, place the joystick in the neutral position, and power the unit back on. If a
problem still exists with your joystick's performance, contact your authorized Pride Provider.
! Check the brakes. This test should be carried out on a level surface with at least three feet of clearance around your
power chair.

To check the brakes:

1. Turn on the unit and turn down the speed level of your power chair.
2. After one second, check the battery condition meter. Make sure that it remains on.
3. Slowly push the joystick forward until you hear the electric brakes click. Immediately release the joystick. You must be
able to hear each electrical brake operating within a few seconds of joystick movement. Repeat this test three times,
pushing the joystick backwards, then left, and then right.
Monthly Checks
! Check for drive tire wear. See your authorized Pride Provider for repair.
! Check the caster wheels for wear. Replace them as necessary.
! Check the caster forks for damage or fluttering which indicates that they may need to be adjusted or have the bearings
replaced. See your authorized Pride Provider for repair.
! Keep your power chair clean and free of foreign material, such as mud, dirt, hair, food, drink, etc.
Yearly Checks
Take your power chair to your authorized Pride Provider for yearly maintenance. This helps ensure that your power chair
is functioning properly and helps prevent future complications.

Storage

Your power chair should be stored in a dry place, free from temperature extremes. When storing, disconnect the batteries
from the power chair. See VI. "Batteries and Charging."
WARNING! If you fail to store the unit properly, the frame can rust and the electronics can be
damaged.
36
C A R E
A N D
www.pridemobility.com
M A I N T E N A N C E
Jazzy Select

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents