Anti-Tip Wheels; To Adjust The Anti-Tip Wheels; To Adjust The Elr Length - Pride Mobility Jazzy 1121 Owner's Manual

V . C O M F O R T

To adjust the ELR length:

1. Remove the two screws from the side of each leg rest extension. See figure 20.
2. Slide the leg rest in or out to the desired length.
3. Reinstall the two screws.

Anti-Tip Wheels

The anti-tip wheels are designed to give your power chair increased stability on rough surfaces. The anti-tip wheels are
preset for smooth surfaces or indoor use only. If you plan on using your power chair on rough surfaces, it may be
necessary to adjust the anti-tip wheels to better suit your needs. The anti-tip wheels may need adjustment if either of the
following occur:
! When coming to a stop, your power chair tips forward excessively.
! The anti-tip wheels constantly rub the ground.
WARNING! Consult your authorized Pride Provider before attempting to change the anti-tip wheel
height! Changing the anti-tip wheel height affects handling under deceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair's
tendency to tilt forward when coming to a stop. You can compensate for this by having your
authorized Pride Provider make a small adjustment to the pre-programmed deceleration setting
in the controller or by moving the seat assembly further to the rear of your power chair.

To adjust the anti-tip wheels:

1. Remove the anti-tip wheel. See figure 21.
2. Remove the nut and bolt on the anti-tip bracket. See figure 21.
3. Raise or lower the anti-tip whee l bracket.
4. Reinstall the nut and bolt on the anti-tip bracket.
5. Reinstall the wheel.
6. Raise or lower the other anti-tip bracket so that it is at the same height.
NOTE: Each drive tire must have 35 psi (2.4
bar) in order for the anti-tip wheels to be
properly adjusted.
24
A D J U S T M E N T S
ANTI-TIP WHEEL BRACKET
ANTI-TIP WHEEL
Figure 21. Anti-Tip Wheel Assembly
www.pridemobility.com Jazzy 1121