One for All Audio Zapper User Manual & Code Book page 19

Advanced Features
To delete a learned function:
It is possible to delete all learned functions or only
individual learned functions.
To delete individual learned functions, follow the
steps as outline below.
1
Press and hold MAGIC until the light blinks
twice (the light will blink once then twice).
2 Press Programme -, Volume -, Volume -
(the LED will blink twice).
3 Press the device key in which the function
will be deleted.
4 Press twice on the learned key which will
be deleted (the LED will blink twice).*
5
If there is another key which you wish to
delete, repeat steps 2-4.
6
The original functions of the AUDIO ZAPPER
will now be present.
* To delete a Shifted Learned function, press
MAGIC before you press the learned key to be
deleted (during step 4).
To delete all learned functions across all modes:
1 Press and hold MAGIC until the light blinks
twice (the light will blink once then twice).
2 Press Programme -, Volume +, Volume -
(the light will blink four times).
Notes:
- During steps 2-8 (pg 17-18), you have approximately 10
seconds to conduct each step. If there is a gap of more
than 10 seconds between two steps, you will have to
start over at step number 2.
- If you learn a function on a key that already performs a
function, the original AUDIO ZAPPER feature
automatically becomes shifted. You can press MAGIC and
then the key to access it.
- The Learning feature is mode specific. Therefore you can
place one learned feature per mode on the same key.
- The AUDIO ZAPPER can learn approximately 16 functions.
- You can replace a learned function by placing another
learned function on top.
- Learning should not be done in direct sunlight or under
incandescent lights.
- Make sure you are using new batteries before following
the instructions above.
- Upon changing the batteries, your learned functions will
be retained.
WWW.ONEFORALL.COM
19