Installation And Connection - Smeg Refrigerator Instructions For Use Manual

Installation and connection

Selecting the room
Installing the appliance
6
• The appliance should be installed in a dry and well ventilated
room. The appliance will operate correctly if the environment
temperature is within the ranges listed in the table below.
The appliance class is indicated on the label with the basic
information on the appliance.
Class
SN (subnormal)
N (normal)
ST (subtropical)
T (tropical)
Appliance installation should be carried out by at least two
persons to avoid any physical injury or damage to the appliance.
• The appliance should stand fi rmly in an upright position on a
suffi ciently solid base. At the front, the appliance is fi tted with
two adjustable legs that can be used to level the appliance.
• Since the appliance, especially when the door racks are fully
loaded, may tilt forward when the door is opened, it should be
secured with a bracket that will prevent tripping. Drill two holes
Ø 8 mm into the wall behind the appliance, at the height of 52
and 112 mm from the fl oor, respectively, and 50 mm from the
left side of the appliance, looking from the appliance front side.
Insert the dowels into the two holes and use the screws to fi x
the bracket. Press the appliance against the wall to that the
bracket is reaching just above the compressor support.
Ambient temperature
from +10°C to +32°C
from +16°C do +32°C
from +16°C do +38°C
from +16°C do +43°C