Recording To A Cassette Tape - Sharp CD-E200H Operation Manual

Recording to a cassette tape

Before recording:
" When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
" SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
" The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
" For recording, use only normal tapes. Do not use metal or
CrO tapes.
" Recording can be operated in the TAPE 2 compartment only.
The TAPE 1 compartment is for playback only.
Erase-prevention tab of cassette tapes:
" When recording on a cassette tape,
make sure that the erase-prevention
tabs are not removed. Cassettes have
removable tabs that prevent accidental
recording or erasing.
" To protect the recorded sound, remove
the tab after recording. Cover the tab
hole with adhesive tape to record on the
tape without the tab.
! Recording from a CD (CDs)
You can record 3 CDs continuously.
1
Press the ON/STAND-BY button to turn the power on.
2
Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3
Press the CD button and load the desired disc.
4
Press one of the 1 - 3 buttons on the remote control to
select the disc to be recorded first.
5
Press the REC PAUSE (TAPE-2
) button.
Recording will be paused.
6
Press the / button to start recording.
" CD playback will start approximately 5 seconds after the
tape starts.
" Recording is started from the selected CD. When the play-
back of the last disc is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
03/2/10 CD-E200H(H)E2.fm
CD-E200H
ENGLISH
Side A
Tab for Tab for
side B side A
E-18
8