System Configuration - Harman Kardon AVR45 Owner's Manual

3. Press the button
i ˜
Set
4. Adjust the delay time by pressing the
buttons g on the remote or
⁄ / ¤
the buttons
¸
Selector
panel until the delay time figure cal-
culated using the formula entered
above appears in the display.
5. If no adjustment is needed for
the center channel delay, press the
button to enter the
i ˜
Set
setting into the AVR45's memory.
If the calculations outlined above
for the center channel delay require
an adjustment, proceed with the
following steps:
6. Select a digital input by pressing
the button
w ˆ
Digital
the buttons on the remote
g
⁄ / ¤
or the buttons
Selector
front panel until either
COAX
appear in the
OPTICAL
Information Display S
for this adjustment, either input may
be selected.

System Configuration

. 7. Press the
8. Select the Dolby Digital mode either
by pressing the front panel
on the front
Digital Selector (
the
Surround Mode Selector y
on the remote, and then pressing the
⁄ ¤
/
until
DOLBY AC-3
Main Information Display S
Ignore any "
that may appear.
9. Press the
the remote or front panel. The words
S DELAY TIME
Main Information Display S
10. Press the
. Press remote once, so that
TIME
on the
¸ Information Display S
or
Main
. Note that
21
button .
i ˜
Set
Dolby
or by pressing
buttons on the remote
g
appears in the
" message
NO DATA
button on
v ı
Delay
appears in the
buttons on the
g
⁄ ¤
/
C DELAY
appears in the
Main
.
11. Press the button
Set
12. Press the
⁄ / ¤
the remote until the desired delay
time for the center channel appears
in the display.
13. Press the button
Set
the setting into the AVR45's memory.
.
Congratulations! You have now completed
the setup, adjustment and calibration of
the AVR45. You are now ready to enjoy the
finest in music and home theater listening.
.
.
i ˜
buttons g on
to enter
i ˜