System connections
Make sure to unplug the AC power lead before making any connections.
AM loop
aerial
Installing the AM
loop aerial
< Assembling >
< Attaching
to the wall >
wall
screws
(not supplied)
■ Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS socket and
position the FM aerial wire in the direction where the
strongest signal can be received.
External FM aerial:
Use an external FM aerial (75 ohms coaxial cable) for
better reception. When an external FM aerial is used,
disconnect the supplied FM aerial wire.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM and GND terminals.
Position the AM loop aerial for optimum reception. Place
the AM loop aerial on a shelf, etc., or attach it to a stand or
a wall with screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead
may cause noise pickup. Place the aerial away from the
unit for better reception.
■ Speaker connection
● Use speakers with an impedance of 4 ohms or more, as
lower impedance speakers can damage the unit.
● Do not mistake the right and the left channels. The right
speaker is the one on the right side when you face the
unit.
● Insert the speaker plug fully with the lever side facing to
the left.
● Hold the speaker plug when removing it from the unit.
Pulling the wire may cause malfunction to the unit.
● Do not allow any objects to fall into or to be placed in the
bass reflex ducts.
● Do not stand or sit on the speakers. You may be injured.
LEFT
RIGHT
SPEAKERS
■ Demonstration mode
● The first time the unit is plugged in, the unit will enter
the demonstration mode. You will see words scroll.
● To cancel the demonstration mode, press the DEMO/
DIMMER button (remote control) during power stand-
by mode. The unit will enter the low power consumption
mode.
● To return to the demonstration mode, press the DEMO/
DIMMER button again.
■ Connecting iPod or iPhone to TV
Photo and video files from iPod or iPhone can be viewed
by connecting the system to TV/monitor.
If the TV/monitor has a video input, connect it to the VIDEO
OUT socket at the back of the unit and set the TV Out on
the iPod or iPhone unit to "ON" position.
Note:
Please make sure to set iPod unit to either NTSC or PAL to
match your TV signal. Please visit Apple's homepage for
further information.
■ AC power connection
After checking all the connections have been made
correctly, plug the AC power lead of this unit into the wall
socket.
Note:
Unplug the AC power lead from the wall socket if the unit
will not be in use for a prolonged period of time.
E-4
Video cable
TV
(not supplied)
To video input socket
Wire
Plug in with the
lever side facing
to the left.
FM aerial
Wall socket
(AC 220 - 240 V ~ 50/60 Hz)