Troubleshooting Chart; Maintenance - Sharp XL-DH330PH Operation Manual

Troubleshooting chart (continued)
■ USB
Symptom
● Device cannot be ● Is there any MP3/WMA file
detected.
● Is the device properly connected?
● Is it an MTP device?
● Does the device contain AAC file
● Playback does not ● Is it a copyright protected WMA
start.
● Is it a false MP3 file?
● Wrong time ● Is Variable Bitrate file being
display.
● Wrong file name ● Is the File Name written in
display.
■ iPod and iPhone
Symptom
● No sound is ● The iPod or iPhone is not playing.
● The iPod or iPhone is not properly
produced.
No image appears
● Is the AC power lead of the unit
on the TV/monitor.
● The video cable is not properly
● The TV/monitor's input selection
● The iPod TV out feature has not
● iPod or iPhone will ● The iPod or iPhone is not making
not charge.
● Using iPod (3
● The iPod or iPhone is not
● "This accessory is ● The iPhone battery is low. Please
not made to work
● iPhone is not properly docked.
with iPhone" or
"This accessory is
not supported by
iPhone" appears
on iPhone screen.
■ Condensation
Sudden temperature changes, storage or operation in an
extremely humid environment may cause condensation inside
the cabinet (CD pickup, etc.) or on the transmitter on the remote
control. Condensation can cause the unit to malfunction. If this
happens, leave the power on with no disc in the unit until normal
playback is possible (about 1 hour). Wipe off any condensation
on the transmitter with a soft cloth before operating the unit.
■ If problem occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1
Set the unit to the stand-by mode and turn the power on again.
2
If the unit is not restored in the previous operation, unplug and
plug in the unit again, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory
by resetting it.
Possible cause
available?
only?
file?
played back?
Chinese or Japanese characters?
Possible cause
connected to the unit.
plugged in?
connected.
is not properly set.
been set to output video.
full contact with the connector.
rd
generation).
supported. Refer to page 6 for
compatible models.
charge the iPhone.
■ Factory reset, clearing all memory
1
Press the ON/STAND-BY button to enter the power stand-by
mode.
2
Whilst pressing down the OPEN/CLOSE button, press the
ON/STAND-BY button until "ALL CLEAR" appears.
Caution:
This operation will erase all data stored in memory including
clock, timer settings, tuner preset, and CD programme.
■ Before transporting the unit
Remove the iPod, USB memory device and disc from the unit.
Then, set the unit to the power stand-by mode. Carrying the unit
with iPod or USB memory device left docked or discs left inside
might damage the unit.
■ Care of compact discs
Compact discs are fairly resistant to damage, however
mistracking can occur due to an accumulation of dirt on the disc
surface. Follow the guidelines below for maximum enjoyment
from your CD collection and player.
● Do not write on either side of the disc, particularly the non-
label side from which signals are read. Do not mark this
surface.
● Keep your discs away from direct sunlight, heat, and
excessive moisture.
● Always hold the CDs by the edges. Fingerprints, dirt, or water
on the CDs can cause noise or mistracking. If a CD is dirty or
does not play properly, clean it with a soft, dry cloth, wiping
straight out from the centre, along the radius.
NO

Maintenance

■ Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
● Do not use chemicals for cleaning (petrol, paint thinner, etc.).
It may damage the cabinet.
● Do not apply oil to the inside of the unit. It may cause
malfunctions.
E-21
YES
Correct