No Operation Off; Power Management - Sharp Aquos LC-32D53X Operation Manual

Basic adjustment settings (Analogue/Digital)

Power Management

When set, the power will automatically shut down if no
signal is input for a certain time.
Press MENU and the MENU screen displays.
1
Press c / d to select "Power Control".
2
• Power control menu displays.
Press a / b to select "Power Management",
3
and then press ENTER.
Press a / b to select "Mode 1" or "Mode 2",
4
and then press ENTER.
Off
Mode 1
Mode 2
Selected item
Off • No power management.
• Factory preset value.
Mode 1 • If no signal inputs for approximately 8
minutes, the power shuts down.
• Even if you start using the PC and the
signal inputs again, the TV stays off.
• The TV turns on again by pressing
POWER. (See page 13.)
Mode 2 • If no signal inputs for approximately 8
seconds, the power shuts down.
• When you start using the PC and the
signal inputs again, the TV turns on.
• The TV turns on again by pressing
POWER. (See page 13.)
NOTE
• If you turn off the power by disconnecting AC cord when
setting "Mode 2" in power management, the TV may not
function properly after turning the power on again. In such
case, press POWER on the remote control unit.
• Pressing POWER on the TV will have the same result.
28
Description

No Operation Off

When set to "Enable", the power will automatically shut
down if there is no operation for 3 hours.
Press MENU and the MENU screen displays.
1
Press c / d to select "Power Control".
2
• Power control menu displays.
Press a / b to select "No Operation Off", and
3
then press ENTER.
Press a / b to select "Enable".
4
• Five minutes before the power shuts down,
remaining time displays every minute.
NOTE
• "Disable" is factory preset value.
Ecology
When set "Yes", the TV activates the following power
saving mode.
• "OPC" set to "On" (Page 23)
• "Standby Mode" set to "Mode 2" (Page 41)
• "No Signal Off" set to "Enable" (Page 27)
• "No Operation Off" set to "Enable" (Page 28)
• "Power Management" set to "Mode 1" (Page 28)
Press MENU and the MENU screen displays.
1
Press c / d to select "Power Control".
2
• Power control menu displays.
Press a / b to select "Ecology", and then
3
press ENTER.
Press a / b to select "Yes", and then press
4
ENTER.
NOTE
• Ecology mode cannot be deactivated by selecting "No".
Each setting must be changed individually to deactivate
Ecology mode.