Installation - Panasonic CQ-FX721N Operating Instructions Manual

Cassette player/receiver with dot matrix lcd and cd changer control
Hide thumbs Also See for CQ-FX721N:
Table of Contents

Advertisement

Installation

E
N
G
L
I
Preparation
S
H
¡Before installation, check the radio operation with anten-
23
na and speakers.
¡Disconnect the cable from the negative (–) battery termi-
nal (see caution below).
¡Unit should be installed in a horizontal position with the
front end up at a convenient angle, but not more than
30°.
30° or less
Caution: Do not disconnect the battery terminals of a
car with trip or navigational computer since all user set-
tings stored in memory will be lost. Instead take extra
care with installing the unit to prevent shorts.
Dashboard
Installation
Installation Opening
The unit can be installed in
any dashboard having an
opening as shown at right. The dashboard should be 4.5
mm - 6 mm thick in order to be able to support the unit.
Installation Precautions
This product should be installed by a professional installer,
if possible.
In case of difficulty, please consult your nearest authorized
Panasonic Service Center.
1. This system is to be used only in a 12-volt, DC battery
system (car) with negative ground.
2. Follow the electrical connections carefully (
Failure to do so may result in damage to the unit.
3. Connect the power lead (red) after all other connections
are made.
4. Be sure to connect the battery lead (yellow) to the posi-
tive terminal (+) of the battery or fuse block (BAT) termi-
nal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation
instructions of the respective equipment before connect-
ing it to this unit.
26
182 mm
a
Page 30).
CQ-FX721N
Supplied Hardware
No.
q
Mounting Collar
w
Mounting Bolt (5 mmø)
e
Power Connector
r
Removable Face Plate Case
t
Trim Plate
y
ISO Antenna Adapter
u
Remote Control
i
Lithium battery (CR2025)
(a) Using the Rear Support Strap (Option)
53 mm
Tapping Screw (Option)
(b) Using the Rubber Cushion (Option)
Item
Diagram
Fire Wall of Car
3 mmø
Hex. Nut (Option)
Rear Support Strap (Option)
wMounting Bolt
qMounting Collar
Rear Support Bracket
(Provided on the car)
Rubber Cushion
(Option)
wMounting Bolt
qMounting Collar
Q'ty
1
1
1
1
1
1
1
1

Advertisement

Table of Contents
loading

Table of Contents