Marantz SR5007 Owner's Manual page 126

Setting items
Levels Test Tone Start : Output test tone.
Set the volume of the test • Front L / F.Height L / Center / F. Height R / Front R / Surround R /
tone to be the same when it
Surr. Back R
is output from each speaker. speaker to output test tone.
z When the "Speaker Config." – "Surr. Back" setting (vpage 121) is
set to "1spkr", "Surr. Back" is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
When "Levels" is adjusted, the adjusted values are set for all the sound
modes.
NOTE
• Speakers set to "None" in the "Speaker Config."
settings are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
"Levels" is not displayed.
Set Defaults : The "Levels" settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select "Set Defaults" and press
ENTER
, the "Reset to the default values?"
prompt is displayed. Select either "Yes" or
"No", and press
DVD
Setting details
z z
/ Surr. Back L / Surround L / Subwoofer : Select
(vpage
ENTER
.
Setting items
Crossovers Crossover : Set the crossover frequency.
Set the maximum frequency • 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
of the bass signal output 250Hz / Individual : Set the crossover frequency for all speakers. See the
from each channel to speaker manual for information concerning speaker crossover frequency.
the subwoofer. Set the
The following settings can be set when the "Crossover" setting is set to
Crossover Frequency to
"Individual".
suit the bass reproduction
• Front / Center / Surround / Surr. Back / Front Height : Select speaker
capability of the speaker
for setting of crossover frequency.
being used.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz : Set the crossover frequency.
• "Crossovers" can be set when the "Bass" – "Subwoofer Mode"
121) (vpage 122) setting is "LFE+Main", or when you have a speaker that
is set to "Small".
• Always set the crossover frequency to "80Hz". When using small
speakers, however, we recommend setting the crossover frequency to
a higher frequency.
• For speakers set to "Small", sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• The speakers that can be set when "Individual" is selected differ
depending on to the "Subwoofer Mode" setting (vpage 122).
• When "LFE" is selected, speakers set to "Small" at "Speaker Config."
can be set. If the speakers are set to "Large", "Full Band" is displayed
and the setting cannot be made.
• If set to "LFE+Main", this setting can be made regardless of the
speaker size.
A : Front speaker A is used.
Front Speaker
Set the front speakers to B : Front speaker B is used.
use. A+B : Both front speakers A and B are used.
NOTE
This can be set when
"Assign Mode" is set to
"Front B" (vpage 121).
123
Speakers
Setting details