Controls And Indicators; Operation - Chicago Electric 95136 Set Up And Operating Instructions Manual

COntrOls And IndICAtOrs

1
Torch Connector
Power switch. Up is ON, down is OFF.
1.
2. digital Amps meter.
cutting current, which will vary during

operation.

3. thermal Overload Indicator lamp.
This light will come on, and the device
will shut down if the tool becomes
overheated. Stop trying to use the
cutter while leaving the power switch
ON to allow the cooling fan to operate,
and the lamp will turn off automatically
when the machine cools down. Please
pay attention to the Rated Duty Cycle
discussed on page 2.
4. Power On light.
5. Power supply Controller.
6. mode selector.
prior to cutting.
7. Working Indicator light.
during cutting operation.
Page 10
7 2
POWer
WOrKIng
Ground Connector
Shows actual
Turns the air supply ON
Will be on
For technical questions, please call 1-800-444-3353.
4
note: Before beginning, please read and
understand all the safety precautions
starting on page 2, and especially
3
the section "Specific Safety Rules"
starting on page 4.
5
1. Mount the metal to be cut to the metal
welding-cutting table. It should be
6
mounted so that the cutting debris falls to
the cement floor.
2. Place the Air Plasma Cutter unit no
closer than six feet from the workpiece to
be cut.
3. Connect an air hose and coupling (not
supplied) from the air supply tank to the
Air Input Coupling at the rear of the unit.
See photo on page 9, bottom. The air
supply must be regulated to between 60
and 80 PSI as read on the Air Pressure
Gauge. The air supply must be dry. It is
recommended to install a moisture filter
(not included) on the compressor. Do not
use an air oiler.
4. Connect the Torch Cable plug into the
twist-lock connector on the lower left unit
front. Twist to lock.
5. Plug in the Grounding Cable into the
Ground Connector on the lower right of
the unit front. Twist to lock.
6. Securely place the clamping end of the
Grounding Cable Clamp to a part of the
workpiece or metal table that is clean
of paint, oil, or dirt. Clamp as close
as possible to the workpiece without
damaging the cable during cutting.
7. Verify that the Power Switch is in the Off
(O) position, then plug the 240 V~ line
cord plug into an appropriate 240 V~
outlet.
OPerAtIOn
SKU 95136