Table of Contents
Advertisement
AssemBlY
Attaching the electric Plug (not supplied):
1.
Before use, a plug must be wired to
the 240 V~ power cable. CAUTION:
This operation must only be done by a
qualified electrician.
2.
The Green wire is ground, the Black
and White wires are both 'HOT' 120 V~
conductors.
3.
Use the plug appropriate to your 240
V~ service outlet. Be sure the circuit
is protected with an appropriate circuit
breaker.
grounding the tool:
Attach a ground wire of at least 14 Ga.
thickness (not supplied) to the screw
on the lower left of the back of the tool
case. Connect the other end of the wire
to an appropriate ground, such as a steel
workbench, steel building member or
grounding electrode.
SKU 95136
For technical questions, please call 1-800-444-3353.
Attaching the Air Supply:
WArnIng: Only use dry air as the gas in
this tool. Use of any other gas, such
as oxygen, acetylene, etc. may cause
explosion.
Handle
Air pressure gauge
1.
A male quick release adapter is mounted
on the rear of the tool. Attach your
pressurized air supply using your female
quick release adapter. Adjust your air
supply to deliver 60-80 PSI at 3.5 CFM.
2.
During operation, you can regulate air
pressure through the Plasma Cutter by
adjusting the knob located on top of the
tool.
3.
If the tool becomes over pressurized,
there is a pressure relief valve on the top
of the unit.
Air pressure
regulator knob
Air input coupling
Page 9
Hide quick links:
Advertisement
Table of Contents
