Summary of Contents for Chicago Electric HARBOR FREIGHT TOOLS 98753
Page 1
Stitch welder Set up and Operating inStructiOnS distributed exclusively by harbor Freight tools 3491 Mission Oaks Blvd., Camarillo, CA 93011 Visit our website at: http://www.harborfreight.com read this material before using this product. Failure to do so can result in serious injury.
There is an increased risk of electric shock if your body is grounded. do not expose welders to rain or wet conditions. Water entering a welder will increase the risk of electric shock. Page 2...
Page 3
The correct welder will do the job bet- ter and safer at the rate for which it was designed. Store idle welders out of the reach...
Page 4
Service have your welder serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the welder is maintained.
Wear ANSIapproved protec tive clothing. This unit draws enough current to cause serious injury or death. Before turning the welder on, check the electrode holder to be sure that there are no protruding screws, and that all insulation is secure. Do not weld unless you are insulated from ground and the work piece.
Use a nonconductive safety mat on the work surface to insulate the op erator from the work surface. Read the manual for the ARC welder that the Stitch Welder will be con nected to. Vibration Safety This tool vibrates during use. Re...
Operating instructions tO preVent death Or SeriOuS injurY: do not touch any metal part of the Stitch welder when it is in use. Read the manual for the ARC (stick) welder being used with the Stitch Welder. If welding on a vehicle; disconnect the negative terminal of the vehicle’s...
Page 8
Adjust the output to no greater than 50 Amps. danger! to prevent serious injury and death. if the operator is not holding the Stitch welder, it must be sitting on a nonconduc- tive, nonflammable surface. The Stitch welder will immediately turn on when the power button is turned on.
partS liSt part description Frame Front Cover Back Cover Solenoid Washer Axis Assembly Plug Assembly Contact Front Spring Back Spring record product’s Serial number here: note: If product has no serial number, record month and year of purchase instead. note: Some parts are listed and shown for illustration purposes only, and are not avail able individually as replacement parts.
limited 90 daY warrantY Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this prod uct is free from defects in materials and workmanship for the period of 90 days from the date of purchase.