Central Machinery 92658 Assembly And Operating Instructions Manual page 15

ASSEMBLY AND OPERATING INSTRUCTIONS (continued)
6. Loosen the Locking Knob (16) on the Fence (13) which will disengage the Front
and Rear Brackets (11 & 17). Place the Fence (13) on the Tile Saw as shown in
FIGURE 5 below. Tighten the Locking Knob (16).
7. To install the Blade Guard (8) first remove the Main Table (2) by removing the 4
bolts (4) located under the Main Table.( See Page 19). Next remove the Locking
Knob (9) and Bolt (7) from the Blade Guard (8), then remove the 3 screws (6) from
the bracket (5). Next insert the lip of the bracket (5) into the slot under the Main
Table (2). Align the holes, then install the 3 screws (6) down through the top.
Replace the Main Table (2) then attach the Blade Guard (8) to the bracket. Adjust
the hight as needed.
Blade Guard (8)
Locking Knob (9)
REV 1/06
SKU 92658 For technical questions, please call 1-800-444-3353.
Main Table (2)
FIGURE 6
Blade Guard (8)
FIGURE 5
Fence (13)
Miter Gauge (14)
Locking
Knob (16)
Front
Bracket (17)
Fence (13)
Page 15