Table of Contents
Advertisement
2. Preparation
2.4 Adjusting the volume
(KX-MB1520/KX-MB1530 only)
Important:
R Before adjusting the volume, set the operation
mode to fax mode. If the MFaxN light is OFF, turn
it ON by pressing MFaxN repeatedly.
MFaxN
Ringer volume
While the unit is idle, press MCN or MDN.
To turn the ringer OFF
Press MCN repeatedly to display "RINGER OFF= OK?".
A MSetN
R The unit will not ring.
R To turn the ringer back ON, press MDN.
Speaker volume
While using the speakerphone, press MCN or MDN.
20
MSetN MCNMDN
2.5 Date and time (KX-MB1520/
KX-MB1530 only)
We recommend you to set the date and time. The other
party will receive your unit's date and time as the header
information.
MFaxN
1
MMenuN A MBNM1NM0NM1N A MSetN
2
Enter the current date/month/year by selecting 2
digits for each.
Example: 3 August, 2011
M0NM3N M0NM8N M1NM1N
3
Enter the current hour/minute by selecting 2 digits for
each.
Example: 10:15 PM (12 hour clock format)
1. M1NM0N M1NM5N
2. Press MGN repeatedly to select "PM".
Press MGN repeatedly to select "AM" or "PM", or
24-hour time entry.
4
MSetN
5
Press MMenuN to exit.
Note:
R To check the current date and time setting,
temporarily change the unit to the fax mode by
pressing MFaxN repeatedly (page 17).
R Your unit's date and time will be used as the header
information for the following:
– When sending faxes (page 38).
R If the date and time is not set correctly, the other party
will receive an incorrect date and time as their
header. This may confuse the other party.
R The accuracy of the clock is approximately ±60
seconds a month.
To correct a mistake
Press MFN or MEN to move the cursor to the incorrect
number, and make the correction.
If you have subscribed to a Caller ID service
The date and time will be automatically set according to
the received caller information.
R To use this feature, make sure the time adjustment
is set to "AUTO" (feature #226 on page 53).
MMenuN
MSetN MFNMEN
Advertisement
Table of Contents
