Models Ci370 & 360 Wall Inlets; Wall Inlet Installation - NuTone VX1000C Installation Instructions Manual

and gradually tighten down each screw a little bit at a
time. (If you completely tighten down one screw at a
time, the mounting plate may pull away from the wall at
the loose end and slip back into the cutout.)
Complete all your wall inlet installations in this manner. If
your cutouts are accurate, each wall inlet will install more
quickly and easily.
Insert the bottom screw
into the inlet cover and
through the other parts.
Give the screw a few turns
until it firmly engages in
the mounting plate. Now,
level and slightly lower
the assembly. Make sure
the wall is sandwiched
between the inner and
outer parts – you'll be able
to feel if mounting plate is
firmly centered on the
inside of the wall.
Hold the inlet in place
MODEL CI370 or 360 SERIES INLETS
(CF361 or CF361F Rough-In)
N O T E :
If 330 Wall Inlet is being used refer to
Model 330 Wall Inlet Installation on next page.
1. If area is clear, cut an inlet opening in the wall
approximately 18" above the floor. Make sure wall
opening and 2 1⁄2" tube hole line up (Figure 32).
FIGURE 32
NOTE: If the wall for mounting the Model 360 inlet is less
than 1⁄2", a spacer must be used. See Figure 26 on page 8
as a guide.
2. Cut a length of tubing that will extend from inlet
opening to a point below floor level (or above ceiling
level in attic installation). Tape low voltage wire to
tube and insert tube through predrilled hole to a
level opposite the
wall opening.
3. Apply cement to
tube and install
flanged wall fitting.
Make sure fitting is
well seated and
sealed (Figure 33).
4. Remove plaster frame
from mounting brack-
e t . Pull low voltage
wire through hole in
bracket and insert
bracket into cutout.
Secure bracket to
flanged fitting with four
screws provided. Be
sure seal is secure
between flange fitting
and mounting bracket
(Figure 34).
18
FIGURE 33