Setting Up The Channel List; Using Initial Setup - Sony WEGA KLV-S23A10 Operating Instructions Manual

ConnecUng_e TV
Setting Up the Channel List
After you finish connecting your TV. you need te run [nitial Setup, which
automatically sets up awtilable channels. Tile Initial Setup screen appears
when you turn on your TV tor the first time after booking it up. If you do not
want to set up the channels at this time, you can do it later by selecting the
Auto Program option in the Channel settings (see page 53).
f___The Auto Program feature does not apply for !nsta!lations that use a
The factory default setting for channel selection is Cable On. For
antenna connectionsl run the Auto Program again after selecting Cable
Off from the settings.
Using Initial Setup To run Initial Setup the first time you turn on your TV
1
Press POWER to turn on the TV,
The Initial Setup screen appears.
2 Press 4"or • to select the on-screen display language. Then press @.
The message "First please connect cable/antenna" appears.
f_._jBy default, Auto Program is set to scan cable TV channels.
3
Press CH + to start Auto Program.
Auto Program automatically creates a list of receivable channels. When
finished, the lowest numbered channel is displayed. When all the receiwtble
channels are stored, the Show/Hide Channels settings appear.
To scan available VHF/UHF antenna channels instead of the cable TV
channels
1
Select
Settings
in WEGA GATE, then go te Channel settings.
2 Set Cable to Off.
3 Start Auto Program by pressing CH +.
To perform Auto Program again, follow the above instructions.
Depending on your signal source, be sure to set Cable to On or Off
accordingly (see page 53).
,_ The Initia! Setup menu wi!l appear each time the -rv is turned on until
you complete the scanning for the available channels.
3O