Connecting Optional Equipment; Vcr, Cable And Antenna - Sony WEGA KLV-S23A10 Operating Instructions Manual

Connecffng_e TV
Connecting Optional Equipment
You can connect a wuiety of optional equipment to your TV. This section
provides SOlne of the individual connections you can make. For multiple
connections please refer to the Quick Setup Guide.
VCR, Cable and
Antenna
"_° The most common setup is
the Cable input into the
VCR Antenna IN, the VCR
Antenna Out to the
VHF/UHF input.
This scenario shows a VCR with Cable signals connected through the video
inputs and the Antenna connected through the VHF/UHF input. The Cable
or VCR signals are selected by the VCR through the video inputs while TV
signal (Antenna) is selected by the TV tuner.
To connect the VCR and cable
1
Connect the CATV cable to the VCR's VHF/UHF input jack.
2 Connect the supplied 75-ohm coaxial cable from the antenna to the
TV's VHF/UHF input jack.
3 Use an A/V and S VIDEO cables to connect the VCR's AUDIO and
S VIDEO output jacks to the TV's AUDIO and S VIDEO input jacks
(VIDEO 1 or 3).
4 Run the Initial Setup Program, as described in "Setting Up the Channel
List" on page 30.
_!f your VCR is not equipped with S VIDEO, use a VIDEO cable
(yellow) instead of the S VIDEO cable.
CATV cable
1
75-ohm
coaxial cable '_
1r
V,F/UaF
Rear of TV t......................
S VIDEO cable
A/V cable
(white)
AUDIO-R
(red)
22