Table of Contents
Advertisement
OpTIONAL FRESh AIR KIT INSTALLATION INSTRUCTIONS
the optional Fresh air Kit is designed to introduce outside air to
the firebox as desired.
It must be installed prior to, or at the time of firebox installation to
framing.
the Fresh air kit must be installed prior to the installation of wall-
board or other finishing materials around the unit.
hardware needed (not provided): 4" aluminum Flex Duct,
2 Band clamps
Tools needed: gloves, Metal snips, 5/16" nut Driver,
Phillips Screwdriver
Caution:
Sharp edges
Slide assembly installation
1.
Begin by removing the rectangular cutout located on the left
side of the unit. Use gloves and sheet metal snips to create
the opening for the air Door assembly to install into. See Fig-
ure 13.
2. Remove the cover plate on the left side of the firebox and dis-
card. See Figure 14a. Some units will not have a cover plate.
For those units, bend the tab out of the way. See Figure 14b.
Figure 14a
Page 10
FOR DELUXE AND pREMIUM FIREBOXES
Figure 13
Figure 14b
3.
insert Slide assembly through the cut-out as shown in Figure
15. Before you fasten ensure that the handle penetrates the
inner firebox wall. See Figure 16. Fasten the Slide Assembly
with the four 10 x 1/2 Hex Head Screws provided.
4. Fasten the Handle Retainer to the firebox side with
two 10 x 1/2 Phillips truss Head Screws as shown in Figure
16.
Figure 15
Figure 16
25476-5-0612
Hide quick links:
Advertisement
Table of Contents
