Setting The Writing Speed - Teac Pico-4 User Manual

3.6 Setting the Writing Speed

The Pico-4 SLAVE drives are capable of writing information to a CD or
CD-ROM drive at double (2X), four times (4X) or eight times (8X) nor-
mal speed. The writing speed is set as described below. Once the speed
is selected, it is used in the CD copying and testing modes. It has no
effect on the compare operations.
1. Press the MODE button until the display shows:
2. Press ENTER.
3. Press the MODE key to cycle between eight-times-speed (8X),
quadruple-speed (4X), and double-speed (2X) mode.
4. Press ENTER to confirm the selection.
NOTE
If you are in doubt what speed will work best, pick 2X first and
experiment with the faster settings later. Usually, however, you
should be able to copy most discs at the 8X speed.
3. Modes
Mode select Mode select Mode select Mode select Mode select
5 Write speed 5 Write speed 5 Write speed
5 Write speed 5 Write speed
Speed select Speed select Speed select Speed select Speed select
8X Write 8X Write
8X Write 8X Write 8X Write
53