Disassembly Procedure For The Lens - Panasonic LUMIX DMC-LX2PP Service Manual

NOTE: (When Assembling)
Confirm the contents as shown below.
• Condition of the screw is tightened.
• Assembling condition of mechanism parts (distortion, space
etc.)
• Dust and dirt of the lens, display condition of the LCD (gradi-
ent etc.)
• Dust and dirt of the LCD
Fig. D14
8.4. Disassembly Procedure for the
Lens
NOTE: When Disassembling and Assembling for the Lens
1. To prevent the lens from catching the dust and dirt, per-
form the following procedures with the CCD unit is install-
ing.
Disassembling procedures for the CCD unit, refer to item
8.6.
2. Take care that the dust and dirt are not entered into the
lens.
In case of the dust is putted on the lens, blow off them by
airbrush.
3. Do not touch the surface of lens.
4. Use lens cleaning KIT (BK)(VFK1900BK).
5. Apply the grease (VFK1829) to the point where is shown
to" Grease apply" in the figure.
When the grease is applied, use a toothpick and apply
thinly.
8.4.1. Removal of the Zoom Motor Unit,
Master Flange Unit, Drive/Direct
Unit and 1st Lens Frame/2nd Lens
Frame Move Unit, 3rd Lens Frame
Move Unit
1. Unscrew the 5 screws (A).
2. Remove the Zoom Motor Unit to the indicated by arrow.
3. Remove the master flange unit.
27