Table of Contents
Advertisement
NOTE: (When Assembling)
Confirm the contents as shown below.
- Condition of the screw is tightned.
- Assembling condition of mechanism parts (distortion, space etc.).
- Dust and dirt of the lens, display condition of the LCD (gradient
etc.).
- Dust and dirt of the LCD
12.4. DISASSEMBLY/ASSEMBLY PROCEDURE FOR THE LENS
NOTE: When Disassembling and Assembling for the Lens
1. To prevent the lens from catching the dust and dirt, perform the
following procedures with the CCD unit is installing.
Disassembling procedures for the CCD unit, refer to item 12.3.9.
2. Take care that the dust and dirt are not entered into the lens.
In case of the dust is putted on the lens, blow off them by airbrush.
3. Do not touch the surface of lens.
4. Apply the grease to the point where is shown in the figure as
"Grease apply" .
- VFK1829.....Other than Cam Frame Unit
- VFK1905.....Only Cam Frame Unit
When the grease is applied, use a toothpick and apply thinly.
35
Advertisement
Table of Contents
