Central Pneumatic 66995 Set Up And Operating Instructions Manual page 4

i. Always assume that the tool con-
tains fasteners. Do not point the tool
toward yourself or anyone whether it
contains fasteners or not.
j. WARNING – Do not fire fastener on
top of another fastener. This is able
to cause the fastener to be deflected
and hit someone, or cause the tool to
react and result in a risk of injury to
persons.
k. WARNING – Remove finger from
the trigger when not driving fas-
teners. Never carry the tool with
finger on trigger, the tool is able to fire
a fastener.
Tool use and care
a. Use clamps or another practical
way to secure and support the
workpiece to a stable platform.
Holding the work by hand or against
the body is unstable and can lead to
loss of control.
b. Do not force the tool. Use the
correct tool for the application. The
correct tool will do the job better and
safer at the rate for which the tool is
designed.
c. Do not use the tool if the trigger
does not turn the tool on or off.
Any tool that cannot be controlled
with the trigger is dangerous and
must not be used until repaired.
d. Disconnect the tool from the air
source before making adjust-
ments, doing tool maintenance,
clearing jams, touching the safety
nosepiece, leaving work area,
loading, or unloading the tool.
Such precautionary measures reduce
the risk of injury to persons.
SKU 66995 For technical questions, please call 1-800-444-3353.
e.
Store the tool when it is idle out of
reach of children and other un-
trained persons. A tool is dangerous
in the hands of untrained users.
f. Maintain the tool with care. A prop-
erly maintained tool reduces the risk
of binding and is easier to control.
g. Check for misalignment or bind-
ing of moving parts, breakage of
parts, and any other condition that
affects the tool's operation. If dam-
aged, have the tool serviced before
using. Many accidents are caused
by poorly maintained tools. There is a
risk of bursting if the tool is damaged.
h. Use only accessories that are
identified by the manufacturer for
the specific tool model. Use of an
accessory not intended for use with
the specific tool model, increases the
risk of injury to persons.
i. Use only those fasteners listed
in the Specifications chart of this
manual. Fasteners not identified for
use with this tool by the tool manu-
facturer are able to result in a risk
of injury to persons or tool damage
when used in this tool.
Service
a. Tool service must be performed
only by qualified repair personnel.
b. When servicing a tool, use only
identical replacement parts. Use
only authorized parts.
Use only the lubricants supplied
c.
with the tool or specified by the
manufacturer.
Page 4