Specifications; Safety Warnings And Precautions - Chicago Electric 40208 Assembly And Operating Instructions Manual

Motor
RPM
Vise Capacity
Table / Vise Angles 35 Degrees Right to Left
Arbor Diameter
Wheel Dimensions 4-1/4" Dia. x 1/8" Thick
Overall Dimensions 9" W x 10" L x 12-1/8" H
Weight
You will need the manual for the safety warnings and precautions, assembly instructions,
operating and maintenance procedures, parts list and diagram. Keep your invoice with this
manual. Write the invoice number on the inside of the front cover. Keep the manual and
invoice in a safe and dry place for future reference.
WARNING: When using tool, basic safety precautions should always be followed to re-
duce the risk of personal injury and damage to equipment.
Read all instructions before using this tool!
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp or wet locations. Don't
expose to rain. Keep work area well lighted. Do not use electrically powered tools in the presence of
flammable gases or liquids.
3. Keep children away. Children must never be allowed in the work area. Do not let them handle
machines, tools, or extension cords.
4. Store idle equipment. When not in use, tools must be stored in a dry location to inhibit rust. Always
lock up tools and keep out of reach of children.
5. Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a
larger industrial tool. There are certain applications for which this tool was designed. It will do the job
better and more safely at the rate for which it was intended. Do not modify this tool and do not use this
tool for a purpose for which it was not intended.
6. Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts.
Protective, electrically nonconductive clothes and nonskid footwear are recommended when working.
Wear restrictive hair covering to contain long hair.
7. Use eye and ear protection. Always wear ANSI approved impact safety goggles. Wear a full face shield
if you are producing metal filings or wood chips.
8. Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running
machines.
SKU 40208

Specifications

115 V, .75A (Load), Direct Drive
4200
0.80" to 0.50"
7/8"
4.85 Lbs.
Save This Manual

Safety Warnings and Precautions

For technical questions, please call 1-800-444-3353.
REV 08/04; 10/04
Page 2