Panasonic Lumix DMC-FX77 Operating Instructions Manual page 145

[Memory card parameter error]/[This memory card cannot be used]
> Use a card compatible with this unit.
–
SD Memory Card (8 MB to 2 GB)
–
SDHC Memory Card (4 GB to 32 GB)
–
SDXC Memory Card (48 GB, 64 GB)
[Insert SD card again]/[Try another card]
•
An error has occurred accessing the card.
> Insert the card again.
> Insert a different card.
[Read Error/Write Error
Please check the card]
•
It has failed to read or write data.
> Remove the card after turning the power [OFF]. Insert the card again, turn the power on,
and try to read or write the data again.
•
The card may be broken.
> Insert a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the
card]
•
Use a card with SD Speed Class with "Class 4" or higher when recording motion pictures in
[AVCHD].
Also, use a card with SD Speed Class with "Class 6" or higher when recording motion pictures
in [Motion JPEG].
•
In the event that it stops even after using a "Class 4" card or higher, the data writing speed has
deteriorated so it is recommended to make a backup and then format (P45).
•
Depending on the type of the card, motion picture recording may stop in the middle.
[Cannot record due to incompatible format(NTSC/PAL) data on this card.]
> If you want to delete some pictures, format the card after saving necessary data on a PC
etc. (P45)
> Insert a different card.
[A folder cannot be created]
•
A folder cannot be created because there are no remaining folder numbers that can be used.
> Format the card after saving necessary data on a PC etc.
in the [Setup] menu after formatting, the folder number is reset to 100.
[Picture is displayed for 16:9 TV]/[Picture is displayed for 4:3 TV]
•
Select [TV Aspect] in the [Setup] menu if you want to change the TV aspect.
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer. (P128,
131)
Others
(P13)
- 145 -
(P45) If you execute [No.Reset]
(P42)
(P43)