Misfeed Removal - Sharp MX-B200 Operation Manual

Indication
While pressing the start
( ) key, "64" is displayed.

MISFEED REMOVAL

When the misfeed (
stop because of a misfeed. When the SPF misfeeds an original sheet, the unit will
stop and the SPF misfeed (
will remain off. For a misfeed of originals in the SPF, see "E: Misfeed in the SPF
(Peripheral device)" (p.84).
1
Open the multi-bypass tray,
and then open the side
cover.
2
Check the misfeed location.
Remove the misfed paper following the instructions for each
location in the illustration below. If the misfeed (
blinks, proceed to "A: Misfeed in the paper feed area" (p.81).
If the misfed paper is seen from this
side, proceed to "C: Misfeed in the
transport area" (p.83).
If paper is misfed here, proceed to
"D: Misfeed in the lower paper feed
area (Peripheral device)" (p.83).
Downloaded From ManualsPrinter.com Manuals
Check the toner cartridge and make sure that the
seal is not still affixed.
) indicator blinks or
) indicator will blink, while the misfeed (
If paper is misfed here, proceed to
"A: Misfeed in the paper feed area" (p.81).
80
Cause and remedy
blinks in the display, the unit will
If paper is misfed here, proceed to
"B: Misfeed in the fusing area" (p.82).
Page
–
) indicator
) indicator
9