Key Operator Assistance Call - Sharp AR-250 Operation Manual

KEY OPERATOR ASSISTANCE CALL

When the copier is in need of service or care not usually performed
by general users, the copier will stop and one of the following
messages listed below will appear.
Message
CHECK STAPLER POSITION OR STAPLE JAM.
THE FINISHER IS OUT OF SERVICE.
PRESS [CA] TO CANCEL JOB.
DUPLEX SYSTEM IS OUT OF SERVICE.
THE DOCUMENT FEEDER IS OUT OF SERVICE.
PRESS [CA] TO CANCEL JOB.
SELECTED PAPER TRAY IS OUT OF SERVICE.
PLEASE SELECT ANOTHER PAPER TRAY.
CALL FOR SERVICE. CODE:
8-28
Remedy
See page 7-12 (AR-FN1N) or 7-27 (AR-FN2) for staple jam
removal. If the trouble cannot be easily remedied, use key
operator program "DISABLING OF STAPLER" (page 8-
25) to prevent the use of the stapler.
Contact your authorised Sharp Service Centre for service.
Contact your authorised Sharp Service Centre for service.
(This message will appear when the optional finisher
(AR-FN1N, AR-FN2) malfunctions.)
Use key operator program "DISABLING OF DUPLEX
COPYING" (page 8-24) to prevent the use of the optional
duplex system. Contact your authorised Sharp Service
Centre for service.
Use key operator program "DISABLING OF DOCUMENT
FEEDER" (page 8-24) to prevent the use of the optional
document feeder. Contact your authorised Sharp Service
Centre for service.
Contact your authorised Sharp Service Centre for service.
With this message, an alphanumeric code will appear to
indicate a malfunction has occurred which cannot be
corrected by the key operator.
Contact your authorised Sharp Service Centre for service.
Be sure to report the alphanumeric code information as
well. This will enable the Service Centre to prepare to
correct the malfunction associated with the code.