Receiving A Message - Panasonic KX-TG7100CX Operating Instructions Manual

TG7100CX(e).book Page 23 Tuesday, May 23, 2006 9:02 AM
L To cancel sending, press {ih}.
Note:
L This unit supports SMS messages of up to
612 characters, however, the maximum
number of characters you can send or
receive may be limited by your SMS
service provider/telephone company.
Consult your SMS service
provider/telephone company for details.
L If your message contains over 160
characters, the message is a long
message and "@@Long Message@@" is
displayed. Your service
provider/telephone company may treat
long messages differently from other
messages. Consult your service
provider/telephone company for details.
L If your phone is connected to a PBX, store
the PBX line access number (page 24).
Sending a saved message
1
{j/OK} i "SMS" i {>}
2
"Send List" i {>}
3
To read a saved message, press {^} or
{V} to select the message. i {j/OK}
4
To send the message, press {j/OK}.
i "Send" i {>}
5
Press and hold {C/T} to erase all
numbers, then continue from step 4,
"Writing and sending a new message",
page 22.
Editing and sending a saved
message
1
{j/OK} i "SMS" i {>}
2
"Send List" i {>}
3
Press {^} or {V} to select the message.
i {j/OK}
4
{j/OK} i "Edit Message" i {>}
i Continue from step 3, "Writing and
sending a new message", page 22.
SMS (Short Message Service)
Erasing saved messages
1
{j/OK} i "SMS" i {>}
2
"Send List" i {>}
3
Press {^} or {V} to select the message.
i {j/OK}
4
{j/OK} i "Erase" i {>}
L To erase all messages, select "Erase
All". i {>}
5
"Yes" i {>} i {ih}

Receiving a message

When an SMS message is received:
– a tone is heard (if the handset ringer is
turned on)
– "Receiving SMS Message" is
displayed
– F is displayed
– the message indicator on the handset
flashes if the message alert feature (page
15) has been turned on
Reading a received message
1
{j/OK} i "SMS" i {>}
2
"Receive List" i {>}
3
Press {^} or {V} to select a message.
L Messages which have already been
read are indicated by a "Q", even if
they were read using another handset.
4
Press {j/OK} to read the message
content.
Note:
L To call the message sender, press {C}
or {s}.
23