Additional Information; Resetting The Recorder; Setting Up The Remote To Control Your Tv - Pioneer RCS-77H Operating Insructions

Additional information

Chapter 15
Additional information

Resetting the recorder

If you need to, you can reset the recorder to all its factory
settings.
1 Make sure that the recorder is on.
2 Press and hold and press
The recorder turns off with all settings reset.
Setting up the remote to control your
TV
You can use the supplied remote to control your TV. To be
able to use this feature you first have to program the
remote with a maker code from the table on the following
page.
1 Switch on your TV.
2 Press and hold down the CLEAR button, then
enter the maker code for your TV.
See the table on the next page for the list of maker codes.
If there is more than one code given for your make, input
the first one in the list.
• If the maker's name of your TV doesn't appear in the
table, you will not be able to use this remote to
control your TV.
3 Point the remote towards your TV and press
TV to check that the remote works with your TV.
If the remote is set up correctly, the TV should switch off.
If it doesn't and there is another code given for your
maker, repeat step 1 with a new code.
Using the TV remote control buttons
The table below shows how to use this remote control
with your TV.
Button
STANDBY/ON.
INPUT
TV VOLUME
TV CHANNEL
What it does
TV Press to switch the TV on/off (standby)
Press to change the TV's video input
Use to adjust the TV volume
Use to change TV channels
15
139
En