About Dv; Setting Up The Remote To Control; Your Tv - Pioneer DVR-541H-S Operating Instructions Manual

Additional information

About DV

Using DV, also known as i.LINK or IEEE 1394-
1995, you can connect a DV camcorder to
this recorder using a DV cable for input of
audio, video, data and control signals.
"i.LINK" and the "i.LINK" logo are
trademarks.
• This recorder is only compatible with DV-
format (DVC-SD) camcorders. Digital
satellite receivers and Digital VHS video
recorders are not compatible.
• You cannot connect more than one DV
camcorder at a time to this recorder.
• You cannot control this recorder from
external equipment connected via the
DV IN jack.
• It may not always be possible to control
the connected camcorder via the DV IN
jack.
• Digital camcorders can usually record
audio as stereo 16-bit / 48 kHz, or twin
stereo tracks of 12-bit / 32 kHz. This
recorder can only record one stereo
audio track. Set the DV Input setting as
required (see DV Input on page 103).
• Audio input to the DV IN jack should be
32 kHz or 48 kHz (not 44.1 kHz).
• Picture disturbance in the recording
may occur if the source component
pauses playback or plays an unrecorded
section of tape, or if the power fails in the
source component, or the DV cable is
disconnected.
• The DV IN jack is an input only. There is
no output functionality.
Setting up the remote to
control your TV
You can use the supplied remote to control
your TV. To be able to use this feature you
first have to program the remote with a
maker code from the table below.
1 Press and hold down the CLEAR
button, then enter the maker code for

your TV.

The LED indicator on the remote controls
lights.
See the table below for the list of maker
codes. If there is more than one code given
for your make, input the first one in the list.
• If the maker's name of your TV doesn't
appear in the table below, you will not be
able to use this remote to control your
TV.
2 Press TV to check that the remote
works with your TV.
If the remote is set up correctly, the TV
should switch on/off. If it doesn't and there is
another code given for your maker, repeat
step 1 with a new code.
14
121
En