Removing The Wheel Axle Bearings - PIAGGIO MSS X9 EVOLUTION 250 Workshop Manual

MSS X9 Evolution 250

Removing the wheel axle bearings

- Take out the clip on the outside of the gearbox
cover.
- Support the hub cover and expel the bearing.
By means of the appropriate tools, remove the oil
guard as in the figure.
Specific tooling
020376Y Adaptor handle
020477Y Adaptor 37 mm
020483Y 30 mm guide
020359Y 42x47-mm adaptor
020489Y Hub cover support stud bolt set
Removing the driven pulley shaft bearing
- As you need to remove the driven pulley shaft, its
bearing and oil guard, remove the transmission
cover as described above.
- Extract the driven pulley shaft from its bearing.
- Remove the oil guard using a screwdriver, work-
ing from inside the bearing and being careful not
to damage the housing, make it come out of the
belt transmission side.
- Remove the seeger ring shown in the figure
Remove the driven pulley shaft bearing using the
modular punch.
Specific tooling
020376Y Adaptor handle
020375Y Adaptor 28 x 30 mm
020363Y 20 mm guide
Engine
ENG - 97