Panasonic KX-TG8621E Operating Instructions Manual page 57

TG862xE(e).book Page 57 Thursday, March 17, 2011 11:40 AM
Panasonic Ni-MH battery
performance during use of a
Bluetooth headset
When the batteries are fully charged,
operating time of the handset using a
Bluetooth headset varies depending on
usage.
– Continuous use of the headset: 5
hours max.
– Not in use: 50 hours max.
Important:
L If you do not use a Bluetooth headset,
it is better to turn off the Bluetooth
setting to save the battery life of your
handset (page 55).
Registering a headset to a
handset
Important:
L Make sure that the Bluetooth headset
is not connected to any other
Bluetooth device.
1
Your headset:
Set your headset to registration
mode.
L Refer to your headset operating
instructions.
2
Handset:
1 (middle soft key) (621
3
Enter your headset PIN.
L Typically, default PIN is "0000".
Refer to your headset operating
instructions.
4
Press M, then wait until a long
beep sounds.
L When registration is complete, g
is displayed. You are ready to use
the headset.
Helpline Tel. No.: U.K. 0844 844 3898 Ireland 01289 8333
Using Bluetooth devices
Connecting/disconnecting a
headset
If you cannot connect the headset and
handset by using the headset, you can
connect by using the handset. To use
your headset with another Bluetooth
device such as a mobile phone, you may
need to disconnect it from the handset.
Important:
L Make sure that the headset is turned
on.
1
1 (middle soft key) (622
L A long beep sounds.
2
{ic}
Note:
L By turning the headset on, it may
connect to the handset automatically.
In addition, if the headset
automatically connects to an outside
line, press {ic} on the handset to
hang up.
Deregistering a headset
A handset can cancel a registration of a
Bluetooth headset.
1
1 (middle soft key) (134
2
{r}: "Yes" s M
L After the headset is deregistered,
the handset beeps and "Add new
device" is displayed.
3
{ic}
Operating a Bluetooth
wireless headset
You can operate the call with your
headset even if you place the handset
on the charger during a call. If you place
the handset on the charger while
listening to recorded messages, the unit
stops message playback and the display
returns to standby mode.
57