Enter The Desired Hour And Minute; Changing The Handset Name - Panasonic KX-TG8621E Operating Instructions Manual

TG862xE(e).book Page 31 Thursday, March 17, 2011 11:40 AM
L If you have set the alarm, the alarm
sounds even if the night mode is
turned on.
Turning night mode on/off
1
1 (middle soft key) (238
2
{r}: Select the desired setting. s
M
L If you select "Off", press {ic}
to exit.
3
Enter the desired hour and minute
you wish to start this feature. s
M
L You can select 24-hour or 12-
hour clock format ("AM" or "PM")
by pressing /.
4

Enter the desired hour and minute

you wish to end this feature. s M
5
{ic}
L When the night mode is set, f is
displayed.
Changing the start and end time
1
1 (middle soft key) (237
2
Continue from step 3, "Turning night
mode on/off", page 31.
Setting the ring delay
This setting allows the handset to ring
during night mode if the caller waits long
enough. After the selected amount of
time passes, the handset rings. If you
select "No Ringing", the handset
never rings during night mode.
1
1 (middle soft key) (239
2
{r}: Select the desired setting. s
M s {ic}
Note:
L When the answering system answers
the call, this feature does not work.
Helpline Tel. No.: U.K. 0844 844 3898 Ireland 01289 8333
Programming
Selecting categories to bypass night
mode
1
1 (middle soft key) (241
2
Select your desired categories by
pressing 1 to 9.
L "Q" is displayed next to the
selected category numbers.
L To cancel a selected category,
press the same dial key again.
"Q" disappears.
3
M s {ic}

Changing the handset name

Each handset can be given a
customised name ("Bob", "Kitchen",
etc.). This is useful when you make
intercom calls between handsets. You
can also select whether or not the
handset name is displayed in standby
mode. The default setting is "No". If you
select "Yes" without entering any
handset name, "Handset 1" to
"Handset 6" is displayed.
1
1 (middle soft key) (1)4
2
Enter the desired name (max. 10
characters; page 59).
L If not required, go to step 3.
3
M
4
{r}: Select the desired setting. s
M 2 times
5
{ic}
Incoming call barring (Caller
ID subscribers only)
This feature allows the unit to reject calls
from specified phone numbers that you
do not want to answer such as junk calls.
When a call is received, the unit does not
ring while the caller is being identified. If
the phone number matches an entry in
the call barred list, the unit sends out a
31