Operation - Makita BTD132 Instruction Manual

For tool with one-touch type
To install the bit, insert the bit into the sleeve as far as it
will go.
1
2
009205
To remove the bit, pull the sleeve in the direction of the
arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the sleeve,
•
the sleeve will not return to its original position and the
bit will not be secured. In this case, try re-inserting the
bit according to the instructions above.
When it is difficult to insert the bit, pull the sleeve
•
and insert it into the sleeve as for as it will go.
After inserting the bit, make sure that it is firmly
•
secured. If it comes out, do not use it.
Hook
1
009207
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.

OPERATION

009222
1. Bit
2. Sleeve
1. Groove
2. Hook
3. Screw
2
3
The proper fastening torque may differ depending upon
the kind or size of the screw/bolt, the material of the
workpiece to be fastened, etc. The relation between
fastening torque and fastening time is shown in the
figures.
Standard bolt
N m
(kgf cm)
120
(1224)
100
(1020)
80
(816)
60
(612)
M10
40
(408)
M8
20
(204)
0 1.0
Fastening time (S)
009218
High tensile bolt
N m
(kgf cm)
120
M12
(1224)
100
(1020)
80
(816)
60
(612)
M8
40
(408)
20
(204)
0 1.0
Fastening time (S)
009219
Hold the tool firmly and place the point of the driver bit in
the screw head. Apply forward pressure to the tool to the
extent that the bit will not slip off the screw and turn the
tool on to start operation.
NOTE:
Use the proper bit for the head of the screw/bolt
•
that you wish to use.
When fastening screw M8 or smaller, choose a
•
proper hammer force carefully adjust pressure on
the switch trigger so that the screw is not
8
M14
M12
(M14)
(M12)
(M10)
(M8)
2.0 3.0
(M12)
M10
(M10)
(M8)
2.0 3.0