Table of Contents
Advertisement
TG6511-6521FX(e).book Page 31 Wednesday, February 24, 2010 1:41 PM
Viewing/editing/erasing bar call
numbers
1
8 i {#}{2}{1}{7}
2
{V}/{^}: Select the desired entry.
L To exit, press {ic}.
3
To edit a number:
~ i Edit the phone number.
i M i {ic}
To erase a number:
W i {V}/{^}: "Yes" i M
i {ic}
Note:
L When editing, press the desired dial
key to add, ^ to erase.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, contact an authorised
service centre.
1
8 i {#}{1}{3}{2}
2
Enter the current 4-digit base unit
PIN (default: "0000").
3
Enter the new 4-digit base unit PIN.
i M i {ic}
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to
the base unit.
Programming
Important:
L The additional handset model
recommended for use with this unit is
noted on page 5. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example, _ is displayed even when
the handset is near the base unit), re-
register the handset.
1
Handset:
8 i {#}{1}{3}{0}
2
Base unit:
Proceed with the operation for your
model.
■ KX-TG6511/KX-TG6512
Press and hold {x} for about 5
seconds. (No registration tone)
■ KX-TG6521
Press and hold {x} for about 5
seconds, until the registration
tone sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seconds.
3
Handset:
Wait until "Base PIN" is displayed.
i Enter the base unit PIN (default:
"0000"). i M
L If you forget your PIN, contact an
authorised service centre.
L When the handset has been
registered successfully, w is
displayed.
31
Advertisement
Table of Contents
