Table of Contents
Advertisement
Auto Setup
Tuning
: Ch 21
EXIT
:
exit
Owner ID
PIN number : ****
Name
: **************
House No
: ***********
Postcode
: ***********
You now have the opportunity
to enter your details and
help the police crack crime
see instruction book.
ENTER
:
select
: store
EXIT
:
exit
Datum / Zeit
Clock set
MANUAL
Time
: 12 : 00 : 00
Date
: 11.
6. 04
VCR Auto Setup with 21-pin Scart cable
(Automatic tuning)
Turn on your television set.
With the Stand-by/on switch turn on the VCR.
Automatic tuning for all available TV stations begins.
Approximate duration is 5 minutes.
After Automatic tuning has finished, press EXIT.
The Owner ID screen will appear.
Owner ID
You can complete the Owner ID now or skip this step and do it later. To do it
later, press the EXIT button. Your VCR is now ready to use.
To set the Owner ID now, press the Numeric buttons or
four-digit PIN number.
Press , to correct the digit.
Make sure that you will remember the PIN number (make a note of it).
Press the ENTER button twice to confirm.
Enter the [Name], [House No] and [Postcode] in the same way.
Press the ENTER button to confirm each entry.
Press the EXIT button to leave the Owner ID screen.
You will now see the TV picture. Your VCR is now ready to use.
If the clock setting menu appears
(Auto clock set was not possible due to a weak signal)
Press
to set the correct time and date.
Press the ENTER button to finish this setting.
Mind that a wrong date or time will influence the programmed recording of TV
programmes (don't forget to change summer time and winter time).
If Auto Setup has previously been completed the VCR will not start Auto Setup
automatically. In this case you can re-start Auto Setup again. See page 29.
If you want to cancel Auto Setup before it has finished, press the EXIT button.
You can restart Auto Setup again. See page 29.
VCR Display
to enter a
11
Advertisement
Table of Contents
