Table of Contents
Advertisement
Initial Setup for ANT./Cable - VCR - TV Connection
Please make all cable or antenna connections before plugging into the AC outlet.
Plugging the VCR Power Cord into an AC wall outlet starts auto channel and clock set.
How to Connect
1
Connect cable from Antenna/Cable to VCR's IN FROM ANT.
jack.
Connect VCR's OUT TO TV jack to TV's ANT. IN jack with
2
included RF Cable accessory.
TV
Doing Initial Setup (Ready to Play)
1
Turn TV on and tune to channel 3.
2
Plug VCR Power Cord into AC wall
outlet. VCR comes on and auto
channel and clock set starts.
• If screen right does not appear,
check VCR - TV connection and, if
TV is tuned to channel 3, try
switching it to channel 4.
• To change VCR's output channel,
please refer to "VCR's Output
Channel" on page 13.
WARNING
When using "Nut type" RF coaxial cables,
tighten with fingers only. Overtightening may
damage terminals.
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com
8
VCR
VHF/UHF
IN FROM ANT.
OUT TO TV
2
Plugging the AC Power Plug into an AC outlet
CH AUTO SET PROCEEDING
CANCEL : STOP
AUTO CLOCK SET
PROCEEDING
CANCEL : STOP
1
IN from
ANT./CABLE
Advertisement
Table of Contents
