Table of Contents
Advertisement
Feature
Changing the maximum
recording time for
*1
incoming messages
Setting the remote
*1
operation ID
Setting the dialling
mode
Setting the ringtone for
*2
outside calls
*1 When this setting is changed using the base unit, the setting for the cordless handset will also be changed, and
vice versa.
*2 This setting can be changed individually for the base unit and the cordless handset.
– To set the cordless handset ringtone for outside calls, see page 49.
7.1.2 Advanced features
Feature
Setting the journal
report to print
automatically
Sending documents
overseas
Feature code
Selection
{1} "1 MINUTE"
{#}{1}{0}
{2} "GREETING ONLY": The unit plays the greeting message but
does not record any incoming messages.
{3} "3 MINUTES" (default)
Note:
L You can also program this feature with the cordless handset
(page 40).
1. {MENU} i {#}{1}{1}
{#}{1}{1}
2. To activate the remote operation feature, enter a 3-digit
remote operation ID.
3. {SET} i {MENU}
Note:
L You can also program this feature with the cordless handset
(page 40).
If you cannot make calls, change this setting according to your
{#}{1}{3}
telephone line service.
{1} "PULSE": For rotary pulse dial service.
{2} "TONE" (default): For tone dial service.
{1} "RINGTONE 1" (default)
{#}{1}{7}
{2} "RINGTONE 2"
{3} "RINGTONE 3"
{4} "RINGTONE 4"
{5} "RINGTONE 5"
{6} "RINGTONE 6"
Feature code
Selection
{0} "OFF": The unit will not print a journal report, but will keep a
{#}{2}{2}
record of the last 30 fax transmissions and receptions.
{1} "ON" (default): The unit will print a journal report automatically
after every 30 new fax transmissions and receptions (page 27).
If you cannot send a fax overseas even if the number is correct
{#}{2}{3}
and the line is connected, activate this feature before sending the
fax.
This feature improves the reliability by reducing the transmission
speed.
{0} "OFF": Deactivates this feature.
{1} "NEXT FAX": This setting is effective only for the next
attempted fax transmission. After transmission, the unit will return
to the previous setting.
{2} "ERROR" (default): When the previous fax transmission fails
and you wish to re-send the document.
Note:
L Calling charges may be higher than usual.
L To deactivate the remote operation feature, press {*}.
7. Programmable Features
43
Advertisement
Table of Contents
