Remote Set Remote Signal Setting Display; Adjustments & Settings (Service Menu); Previous Error Error Display - Mitsubishi CP910E Operation Manual

ADJUSTMENTS & SETTINGS (SERVICE MENU)

REMOTE SET Remote signal setting display

BUSY LEVEL Selects when the BUSY signal of the remote terminals 1 and 2
output on the rear panel.
LOW The VCP cannot accept the remote input signal when the signal is
"LOW".
HIGH The VCP cannot accept the remote input signal when the signal is
"HIGH".
• The default setting is "HIGH".
BUSY 1,2 SELECT Selects when the BUSY signal of the remote terminals 1 and 2
output on the rear panel.
PRINTING Outputs BUSY signal during printing.
MECHA ERR Outputs BUSY signal when a mechanical error occurs in this unit or
IC chip is not installed.
MEDIA ERR Outputs BUSY signal when an error for paper or ink sheet occurs.
MEMORY STOP Outputs BUSY signal when MEMORY button is not functioning.
STROBE 1V After outputting BUSY signal, memory is taken in by waiting to 1
vertical period.
STROBE 2V After outputting BUSY signal, memory is taken in by waiting to 2
vertical periods.
REMAINING Outputs BUSY signal when the remains of ink sheet becomes the
value set in REMAINING BUZZER.
• When either STROBE 1V or STROBE 2V is set to OFF, the other is available for
setting.
SYNCHRONOUS SETTING FOR MEMORY
2
STROBE : 1V, BUSY LEVEL : HIGH in REMOTE SET of SERVICE MENU
V SYNC
BUSY OUTPUT
STROBE : 2V, BUSY LEVEL : HIGH in REMOTE SET of SERVICE MENU
V SYNC
BUSY OUTPUT
The numbers in the above figures are just references. The timing may be different
according to the setting.

PREVIOUS ERROR Error display

This function displays the most recent type of error.
Image meorizing
a
a=approx.820 sec.
Image memorizing
REMOTE SET
BUSY LEVEL LOW/HIGH
BUSY1,2 SELECT
PRINTING OFF/1/2/1&2
MECHA ERR OFF/1/2/1&2
MEDIA ERR OFF/1/2/1&2
MEMORY STOP OFF/1/2/1&2
STROBE 1V OFF/1/2/1&2
STROBE 2V OFF/1/2/1&2
REMAINING OFF/1/2/1&2
PREVIOUS ERROR
NO ERROR
NO ERROR
NO ERROR
43