On Screen Messages - Panasonic Viera TX-26LM70L Operating Instructions Manual

Problem
No sound is produced
Sound level is low
or sound is distorted
Sound is unusual
Pictures from external equipment
are unusual when the equipment
is connected via HDMI
An error message appears
"VIERA Link" function
does not work
TV unit goes into
"Standby mode"
The remote control
does not work
An error message appears

On screen messages

Problem
On screen messages
All tuning data will be erased
Are you sure ?
DOWNLOAD IN PROGRESS PLEASE WAIT
Feature not available
Incorrect PIN Number
No recording - Check Tape or Disc
No recording - UNKNOWN REASON
Please check settings and connections on
HDMI devices.
No stations found
Please insert the aerial
Please wait.
Recording in progress
Recording stopped - TV source changed
Unable to download, Check Equipment
WARNING
All current tuning data will be erased
Actions
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
•
Sound signal reception may be deteriorated.
•
Set "NICAM" (p. 17) in the Sound menu to "Off".
•
Set the sound setting of the connected equipment to "2ch L.PCM".
•
Check the "HDMI1 input" setting in the Sound menu. (p. 17)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 17)
•
Is the HDMI cable connected properly? (p. 26)
•
Turn Off the TV unit and equipment, then turn them On again.
•
Check an input signal from the equipment. (p. 29)
•
Use an equipment compliant with EIA/CEA-861/861B.
•
Contact the authorized Service Centre.
•
Switch the TV unit on again with the equipment on.
•
Set "VIERA Link" to "Off", then set to "On" again. (p. 24)
•
The sleep function is activated.
•
The TV unit enters "Standby mode" about 30 min. after broadcasting ends.
•
Are the batteries installed correctly? (p. 6)
•
Has the TV unit been switched On?
•
Follow the message's instructions.
•
If the problem persists, contact the authorized Service Centre.
Actions
Actions / Meanings
•
"Shipping condition" will erase all tuning data.
•
Make sure the operation is with your desire.
•
Q-Link channel download is in progress.
•
Check the Q-Link connection and setting (p. 22).
•
The impossible source (Component / HDMI) to be record.
•
The PIN number you entered is wrong.
•
The tape or disc may be "write protected", missing or damaged.
The equipment may already be recording.
•
The recording cannot be done by any reason. Check the equipment.
•
Disc or tape may be full.
•
Communication error in VIERA Link function (p. 24).
•
No signal can be found in Auto setup.
•
A function is in progress.
•
The recording equipment is recording the programme signal from
its own tuner. You can turn the TV off and leave the equipment
recording in the normal way.
•
Direct TV recording will stop if channel or input source is changed.
•
The tape or disc is active. Stop the equipment and try again.
•
Auto setup will be erased all present tuning data (p. 19).
31