Panasonic TH-37PE30 Operating Instructions Manual page 9

Quick Start Guide
2
Ensure that the VCR or DVD Recorder is in Standby
mode.
Press the switch on the TV set to turn the set on.
To switch the TV set to Standby mode, press the
button on the remote control.
The TV set can be switched on by pressing the
button again if it was switched to Standby mode.
Note:
This TV will still consume some power as long as the
mains plug is still inserted into the wall socket.
3
Programmes will appear immediately if your dealer has programmed
the TV for you.
If the TV has not been programmed for you then Auto setup will begin.
The TV will search for Analogue stations and DVB stations:
TV stations will be located, sorted into order and stored ready for use.
Stations are sorted into the following order:
• DVB Stations: Are sorted by their logical channel number sent by
the broadcasters, which cannot be moved or changed.
• Analogue Stations: Are sorted into channel order, but can be
changed to your preference. See page 17.
The sorted programme order depends upon the TV signal, the
broadcasting system, and reception conditions.
4
TV to VCR or DVD Recorder Download
If a "Q-Link", "NEXTVIEWLINK" or compatible recording device has
been switched On and connected to a Scart terminal before starting
Step 2, programme information will be downloaded to that device.
Only the analogue programme positions will be downloaded to the recording device, in the correct order. See page 31.
Not all VCRs / DVD Recorders support this download of programme information, some may require to be
started manually.
Refer to the recording device's operating instruction book.
If a recording device other than those described above has been connected, then there will be no download operation.
Notes:
• If the recording device has not accepted download data from the TV, you may need to select the Download
option from the device's menu system. Refer to the recording device's operating instruction book.
• If Q-Link is not operating correctly, check the following :
The Scart cable is connected to the TV's Scart terminal, AV2 or AV4, and correctly setup in the menu.
The Scart cable is connected to the recording device's compatible (Q-Link, NEXTVIEWLINK or similar
technology) Scart terminal.
The Scart cable is a "fully wired" type.
• For further information on Q-Link and connecting equipment, see page 31, 46, 50.
Power Indicator
Standby : Red
On : No Light
DVB Indicator
DVB system active for recording
or DVB tuner lock on : Orange
Otherwise : No Light
Remote control signal sensor
C.A.T.S sensor
Plasma C.A.T.S (Contrast Automatic Tracking System)
Plasma C.A.T.S automatically senses the ambient light
conditions and adjusts the brightness and gradation
accordingly, to optimise contrast.
(Effective when Viewing mode is set to Auto.)
CH44
AUTO SETUP IN PROGRESS
SEARCHING :
21
EXIT : To exit
DVB Auto Setup
Please wait !
Prog. Channel Service Name
46 40 BBC 5L Sportex
47 40 BBC R5 Live
48 40 CBeebies
49 40 BBC Four
50 40 BBC PARLINT
This will take about 3 mins.
DOWNLOAD IN PROGRESS
Remote control unavailable
MODE
OK
N
1 2 3
4 5 6
7 8 9
0
C
IDTV
PLEASE WAIT
68
21 68
Net ID TS ID Quality
12302 16384 8
12302 16384 8
12302 16384 8
12302 16384 8
12302 16384 8
PLEASE WAIT
Programme : 63
9