Common Interface Module Menu - Panasonic TH-37PE30 Operating Instructions Manual

Common Interface Module menu

The Common Interface Module menu provides access to software contained on Common Interface (CI) Modules.
These can be inserted in the "CI" slot located at the rear of the TV.
IMPORTANT NOTES:
Switch off the TV using the front panel switch before inserting or removing a module.
If you are installing a TV software update, please follow the dedicated instructions supplied with the module.
Insert the CI module:
Some Common Interface Modules may be a two piece design consisting
of a card reader together with the viewing card. When using this design
of card, first insert the card reader firmly into the CI slot on the TV.
Secondly, insert the viewing card into the reader.
Switch on the TV.
During DVB mode
Press the MENU button.
Move to choose Setup menu.
Access Setup menu.
Move to choose DVB System Setup.
Access DVB System Setup.
Move to choose Common Interface Module.
Access Common Interface Module.
Access the module.
If no module is inserted the message "No Module Inserted" will be displayed.
(If you have inserted a module, check that it is fully inserted.)
The features that now appear on screen are dependent on the contents of
the selected Common Interface Module.
Refer to the instructions supplied with the card or contact the vendor.
In all cases, it is possible to navigate the pages using buttons on the remote
control, but because the commands available must apply to all manufacturers
of DVB equipment, some on screen commands may not correspond exactly
to the remote control buttons.
For example:
For the on screen command 'select' or 'go', use the OK button.
If you see the
If you see a line of key words displayed in red, green, yellow
and blue, use the coloured buttons to operate the functions.
The EXIT button should always allow you to exit the CI software.
24
symbols, use the cursor keys.
MENU
Main menu
Setup menu
DVB Timer programming
DVB Tuner lock
DVB Auto Setup
DVB System Setup
New Service Message
Shipping condition
Q-Link
AV2 out
Off timer
Child lock
Side panel
OK
Power save
Power on preference
DVB System Setup
Signal Quality
Common Interface Module
Favourites Setup
Preferred Subtitles
System Update
Display Timeout
Screensaver Active
EXIT
Settings
Common Interface
Slot 1: No module inserted
MODE
OK
N
1 2 3
4 5 6
7 8 9
0
C
IDTV
P i c t u r e menu
Sound menu
Setup menu
Off
Access
Off
AV2
Monitor
Off
Off
High
Off
TV
Access
English
3 seconds
After 2 minutes
Default
Access