Mackie ONYX 1640i Owner's Manual page 38

Front Mounting the Pod Section
Tools and qualifications:
1. Phillips screwdriver.
2. Pod Relocation Operator's General Journeyman's Certification License (PROGJCL grade III or higher)
from a Mackie-accredited Four-Year Pod Relocation Technical Institute.
Procedure:
1. Turn off the mixer, and disconnect the power cord, and all connecting cords.
2. Place the mixer face down on a soft and dry flat surface.
3. Remove the 14 screws as shown below and keep them handy, as you will need them again. Only one screw
from each side of the trim is removed; it is the silver flathead screw all by his lonesome on the Pod end
of the mixer. Additionally, there are four screws on each side of the mixer attaching the Pod to the mixer.
Finally, there are four screws for the bottom wire cover plate that must also be removed. (Cables not shown
for clarity.)
4. Gently pull straight back on the Pod until it stops.
38 Onyx 1640i