Miele DA 406 Operating And Installation Instructions page 19

Hide thumbs Also See for DA 406:
Table of Contents

Advertisement

The controls may suffer
discolouration or damage if soiling is
left on them for too long. Remove
soiling straight away.
Observe the General notes on cleaning
earlier in this section.
Do not use stainless steel cleaning
agents on the controls.
The re-usable metal grease filters in the
appliance remove solid particles
(grease, dust, etc.) from the kitchen
vapours, preventing soiling of the
cooker hood.
The grease filters should be cleaned
regularly (at least every 3-4 weeks) to
avoid a build-up of grease but always
clean immediately the grease filter
touch control lamp comes on.
An oversaturated filter is a fire
hazard.
^ To take out the grease filters, release
the locking clip on the filter, lower the
filter 45°, unhook it at the back and
remove it.
To avoid damaging the filter or the
hob below, make sure you hold the
filter securely at all times when
handling it.
^ Clean the filters
-
with a soft nylon brush,
warm water and a little washing up
liquid.
-
upright in the lower basket, and wash
on a 65° programme, ensuring that
the spray arm is not obstructed.
Depending on the cleaning agent
used, cleaning the filters in a
dishwasher can cause permanent
discolouration to the surface.
However, this will not affect the
functioning of the filters in any way.
place filters
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents