1. Manuals
  2. Brands
  3. Miele Manuals
  4. Ventilation Hood
  5. DA 403
  6. Operating and installation manual

Miele DA 400 Operating And Installation Manual

Cooker
Hide thumbs Also See for DA 400:
Table of Contents

Advertisement

Quick Links

See also: Operating and Installation Instruction
Operating and installation instructions
Cooker hoods
DA 400, DA 400 EXT
DA 403, DA 403 EXT
en - GB
To avoid the risk of accidents
or damage to the appliance
it is essential to read these
instructions before it is installed
and used for the first time.
M.-Nr. 07 260 930

Advertisement

Table of Contents
loading

Related Manuals for Miele DA 400

Summary of Contents for Miele DA 400

  • Page 1 Operating and installation instructions Cooker hoods DA 400, DA 400 EXT DA 403, DA 403 EXT en - GB To avoid the risk of accidents or damage to the appliance it is essential to read these instructions before it is installed and used for the first time.

  • Page 2: Table Of Contents

    Miele|home ........

  • Page 3: Caring For The Environment

    Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment.

  • Page 4: Warning And Safety Instructions

    Warning and Safety instructions This appliance is not intended for This appliance complies with all use by persons (including children) relevant local and national safety with reduced physical, sensory or requirements. Inappropriate use mental capabilities, or lack of can, however, lead to personal injury experience or knowledge, unless they and damage to property.

  • Page 5: Technical Safety

    Technical safety Installation, maintenance and repairs may only be carried out by a Before installation, check the cooker Miele authorised person in accordance hood for visible signs of damage. with current national and local safety Under no circumstances should you regulations.
  • Page 6 These models may only be combined with a Miele external motor. This appliance may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk...
  • Page 7 The Miele DSM 400 control module as ensuring that the cooker hood can offers the possibility of combining other only be switched on when the heating components with the cooker hood (see appliance is switched off or vice versa.

  • Page 8: Correct Use

    Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé...
  • Page 9 Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.

  • Page 10: Description Of The Appliance

    Description of the appliance...
  • Page 11 Description of the appliance Cover plate Touch control for the grease filter Telescopic tower The indicator lamp for the grease filter touch control lights up when the grease Canopy filters need to be cleaned. Grease filters The touch control is used: Charcoal filter –...

  • Page 12: Modes Of Operation

    Modes of operation . . . air recirculation: The cooker hood works with (available as an optional extra with a conversion kit and charcoal filter: see "Technical Data") . . . air extraction: The air is drawn in, cleaned by the The air is drawn in and cleaned first by grease filters and directed outside.

  • Page 13: Miele|Home

    Miele electric hob with onset controls. This module must be installed by a Miele service technician or suitably For communication to take place, the qualified electrician.

  • Page 14: Operation

    The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the Miele Control module ^ Press the run-on option touch control DSM 400 then the fan cannot be for approx. 10 seconds. The first fan switched on if the window is shut.

  • Page 15: Run-On Option

    Operation Run-on option It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction "I" and "IV" will flash if the automatic or recirculation mode.

  • Page 16: Switching The Lighting On

    Operation Switching the lighting on Safety cut-out The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting touch ^ Pressing the On/Off touch control will control to switch on the hob lighting.

  • Page 17: Filter Operating Hours Counter

    Operation ^ Press the charcoal filter touch control Filter operating hours counter for about 3 seconds. The number of hours the appliance has been in operation is stored in memory. The indicator lamp for the touch control will go out. Reading the filter operating hours counter To check the percentage of time set...
  • Page 18 Operation Filter operating hours counter The indicator lamp for the grease filter touch control and one of the "– / +" You can set the operating hours touch control lamps will flash. counter to suit the type of cooking you –...
  • Page 19 Operation Setting and altering the charcoal filter operating hours counter (with recirculation mode) The charcoal filter is needed for The "– / +" control lamps show the time recirculation mode. which has been set: 1st lamp from the left = 120 hours The cooker hood is set at the factory for 2nd lamp from the left = 180 hours extraction mode.

  • Page 20: Cleaning And Care

    (This infomation does not apply to the controls). General notes Stainless steel surfaces can be cleaned The surfaces and controls are using the Miele E-cloth, or with a susceptible to scratches and proprietary non-abrasive cleaning abrasions. Please observe the agent designed specifically for use on following cleaning instructions.

  • Page 21: Grease Filters

    Cleaning and care Controls The controls may suffer discolouration or damage if soiling is left on them for too long. Remove soiling straight away. Observe the General notes on cleaning earlier in this section. Do not use stainless steel cleaning agents on the controls.
  • Page 22 65°C programme, ensuring the spray arm is not obstructed. If a Miele dishwasher is being used, select the Sensor wash programme. When putting the grease filters back ^ Use a mild dishwasher detergent.

  • Page 23: Fitting And Replacing The Charcoal Filter

    – if it is no longer effective in absorbing New filters can be purchased from kitchen odours. your Miele dealer or from the Miele Spare Parts Department. It should, however, be replaced at least See back cover for contact details, every 6 months.

  • Page 24: Changing A Halogen Lamp

    Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that – it is switched off at the isolator, or – the screw-out fuse is removed (in countries where this is applicable).

  • Page 25: After Sales Service

    In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance.

  • Page 26: Appliance Dimensions

    4) Height range for appliance in recirculation mode 5) Ventilation grille position for recirculation Exhaust connection C 150 mm (not needed for recirculation mode) DA 400 (Ceiling fixing viewed from above) DA 403 (Ceiling fixing viewed from above)

  • Page 27: Safety Distance Between Hob And Cooker Hood (S)

    - 650 mm above an open grill from the Miele range. - 650 mm above gas cookers/hobs If this cooker hood is installed above a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood.

  • Page 28: Installation

    Installation Assembly parts Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and Safety instructions" at 4 screws 8 x 60 mm with the beginning of this booklet. 4 washers and This is particularly crucial when 4 plugs S 10 to secure the cover plate...

  • Page 29: Electrical Connection

    Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations a residual current device (RCD) with a...

  • Page 30: Operation With Dsm 400 Control Module

    Operation with DSM 400 control module The Miele DSM 400 control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g.

  • Page 31: Connection To A Light Switch

    Operation with DSM 400 control module Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it (depending on model) via a light switch in the house. Installation The control module is fitted in the tower after the cover plate has been unscrewed from the ceiling.

  • Page 32: Connection For Air Extraction

    Connection for air extraction – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...

  • Page 33: Condensate Trap

    Connection for air extraction Important! Cooker hoods designed for use with an external motor (...EXT models) have an If the exhaust ducting is to run through integrated condensate trap. rooms, ceiling space etc. where there may be great variations in temperature Silencer between the different areas, the problem of condensation will need to...

  • Page 34: Technical Data

    Weight DA 400....38.4 kg DA 400 EXT ....35.2 kg DA 403.
  • Page 36 Alteration rights reserved / 4309 M.-Nr. 07 260 930 / 02...

This manual is also suitable for:

Da 403 ext

Table of Contents