Timer Programming - Panasonic Viera TX-L32S20B Operating Instructions Manual

Timer Programming

The Timer Programming menu allows you to choose programmes that you wish to remind watching or
record to the external recorder. At the correct time, the TV will tune to the correct channel automatically
to record even if the TV is in Standby mode.
TV Guide may also be used to set timer programming event
Timer Programming can store up to 15 events.
For recording using Timer Programming, the TV must be either On or in standby. For reminders to be displayed,
the TV must be On.
No other channel can be selected while Ext Rec. of a Timer Programming is in progress.
It may not be possible to record an encrypted programme (which is copy-protected).
When recording programmes, be sure to make the proper settings on the recorder connected to the TV.
If a compatible recorder with Q-Link or similar technologies is connected to the TV (p. 60) and the "Link Settings"
(p. 30) are correct, no setting of the recorder is required. Also read the manual of the recorder.
If the recorder is not compatible with Q-Link or similar technologies, set "Q-Link" in the Setup Menu (p. 30) to the
connected terminal (AV1 or AV2), and set the timer of the recorder in addition to the Timer Programming on the
TV. For preparations of a recorder, read the manual of the recorder.
Recordings are always in standard definition composite video via SCART, even if the original programme is in
high definition.
INPUT
TV
MENU
EXIT
abc def
ghi jkl mno
pqrs tuv wxyz
To return to TV
EXIT
To unlock the tuner
(stop recording)
EXIT
Note
Check that the LED is orange. If not, timer programmes are not active or not stored.
Timer Programming reminder messages will remain displayed until one of the following occurs:
• You press the OK button to view the programme or the EXIT button to cancel the reminder.
• The timer programming event that the reminder is set for ends.
"!" identifies that any timer programming events have overlapped. "Ext Rec." is given priority over "Reminder".
When two or more "Ext Rec." overlap, the first timer programming event starts and finishes as programmed. The
next timer programming event will then start.
2 mins. before the starting time, a reminder message appears if you are watching TV.
• To remove the message and start the programme
Ext Rec. of Timer Programming will automatically change to the programmed channel 10 seconds before the
start time.
To stop recording of the timer programming event, it may be necessary to stop the recorder manually.
Ext Rec. of Timer Programming will be performed even if the TV is in Pause Live TV recording (p. 63). In this
42
case, the Pause Live TV recording will be cancelled.
Timer Programming from Menu
Select the tuner you want to use (DVB or Analogue)
1
TV
Display the menu
2
MENU
Select "Setup"
3
Main Menu
Picture
Sound
Setup
Select "Timer Programming"
4
Setup Menu
Timer Programming Access
Off Timer Off
Link Settings
Child Lock
DVB Tuning Menu
Display Settings
Network Setup
System Menu
Other Settings
5
Set
.
(p. 19)
access
select
access
select
• To cancel the Timer Programming
EXIT