Table of Contents
Advertisement
Turning the Power On
HDD SAFETY Switch
Important: Keep unit on flat, level surface while in
use. If the unit is lifted up or placed on a surface that is
not flat and level, the PC card HDD operation will be
stopped by the HDD SAFETY Switch to protect it from
damage.
• If the unit receives a strong impact, the PC Card HDD
data may be corrupted. It is advisable to keep this
switch ON. (ON is the default setting.)
• If the HDD SAFETY Detection Switch, located under
the unit, is activated, unit operation will be stopped
and a warning message will appear on the TV screen
and unit LCD. In this case, place unit on a flat, level
surface. Normal operation will resume. Any copy
operations resume from precise point where copying
was interrupted.
• If the HDD SAFETY Detection Switch is activated
while the unit is connected to a PC, "SAFETY MODE
PUT IT DOWN" will appear on the unit LCD. Copy
operation in progress at this time will be suspended,
and computer errors may also occur.
Remaining Battery Life Display
COPY MODE
COPY MODE
BATT.
BATT.
When the BATT.
and the battery icon
power off, are inoperable. Connect the AC adaptor or recharge the battery. If the
battery completely runs down during copying, the copying is stopped and power is
shut off. It may not be possible to play back the data that was being copied at this
time.
It is advisable to fully charge the battery before using the unit. (p. 17)
20
Eng.p18-20.p65
HDD
SAFETY
Detection
HDD stops and all
operations are interrupted.
COPY MODE
COPY MODE
BATT.
BATT.
start flashing, all buttons, except
20
2003/02/13, 16:48
HDD SAFETY
(ON/OFF)
BATTERY
LOW
Advertisement
Table of Contents
