Rs485 Setup - Panasonic WV-CW860 Operating Instructions Manual

(8) Digital Noise Reduction (DNR)
DNR may be used to improve quality under low light condi-
tions. There are 4 levels of DNR, which may be selected
depending on local site conditions. Factory default setting:
LOW1
You may need to try different settings to find the most suitable
conditions for your application.
Move the cursor to DNR and select LOW1, LOW2, HIGH1 or
HIGH2 by moving the joystick to the right or left.
LOW1: DNR level is low. The after-image remains.
LOW2: DNR level is low. The after-image is reduced.
HIGH1: DNR level is high. The after-image remains.
HIGH2: DNR level is high. The after-image is reduced.
(9) To Close the SPECIAL2 Menu
Move the cursor to RET and press the CAM (SET) key.
The setup menu appears on the monitor screen.
Reset to the Factory Default Settings
Any of the above settings plus the ALC/MANUAL level control and
phase adjustments can be reset to the factory default settings by
placing the cursor over the desired mode and then pressing the
F2 button of the WV-CU550B.
For the WV-RM70, keep pressing the Right and Left switches
simultaneously for 2 seconds or more.

RS485 Setup

Initial Camera Communication Parameters
In an RS485 chain, the matrix switcher, PC, controllers and cam-
eras should be set to the same protocol and parameters for com-
munication. Confirm the system protocol and parameters prior to
setting the communication parameters for the camera.
The initial communication parameters for WV-CW860 and WV-
CW864E are shown on the RS485 setup menu below. Other than
the on-screen setup parameters, the 4-bit DIP switch may be used
to select 2-line (Half Duplex) or 4-line (Full Duplex) communica-
tion.
Changing the Camera Communication
Parameters
You can remotely control this camera by using a specified exten-
sion unit such as a computer with a modem.
1. Display the SET UP MENU. Move the cursor to RS485 SET UP
and press the CAM (SET) key. The RS485 SET UP menu
appears on the monitor.
2. Move the cursor to the item and select the parameter by mov-
ing the joystick to the right or left.
47
** SPECIAL2 **
CHROMA GAIN •••• ••••
|
AP GAIN •••• | ••••
PEDESTAL • •••••••
|
- +
BW OFF
BURST(BW) ON
REFRESH PUSH SW
CAMERA RESET PUSH SW
DNR LOW1
RET
** SPECIAL2 **
CHROMA GAIN •••• ••••
|
AP GAIN •••• | ••••
PEDESTAL • •••••••
|
- +
BW OFF
BURST(BW) ON
REFRESH PUSH SW
CAMERA RESET PUSH SW
DNR LOW1
RET
RS485 Setup menu
** RS485 SET UP **
UNIT NUMBER 1
SUB ADDRESS -----
BAUD RATE 19200
DATA BIT 8
PARITY CHECK NONE
STOP BIT 1
NOT USE
XON/XOFF
WAIT TIME OFF
ALARM DATA AUTO2
DELAY TIME ---
RET